Holzmann SM 100 User Manual - page 18
SAFETY
HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at
Seite 18
SATINIERMASCHINE / BURNISHING MACHINE SM 100
12
SAFETY
12.1
Intended Use
The machine must only be used for its intended purpose! Any other use is deemed to be a case of
misuse.
The machine is used for:
For dry polishing, sanding with sanding sheets and brushing on surfaces of metal, stone, plastic,
wood, composite materials, paint/varnish, filler and similar materials.
To use the machine properly you must also observe and follow all safety regulations, the
assembly instructions, operating and maintenance instructions lay down in this manual.
All people who use and service the machine have to be acquainted with this manual and must be
informed about the machine's potential hazards.
It is also imperative to observe the accident prevention regulations in force in your area.
The same applies for the general rules of occupational health and safety.
Any manipulation of the machine or its parts is a misuse, in this case HOLZMANN-Machines and
its sales partners cannot be made liable for ANY direct or indirect damage.
Even when the machine is used as prescribed it is still impossible to eliminate certain residual risk
factors.
W A R N I N G
Use only abrasive allowable for this machine!
Never use a damaged abrasive!
Use the machine never with defective or without mounted guard
HIGHEST RISK OF INJURY!
Ambient conditions
The machine may be operated:
humidity
max. 70%
temperature
+5°С to +40°С (+41°F to +104°F)
The machine shall not be operated in areas exposed to increased fire or explosion hazard.
Prohibited use
The operation of the machine outside the stated technical limits described in this manual is
forbidden.
Operation of the machine function without emergency device is prohibited.
The use of the machine not according with the required dimensions is forbidden.
The use of the machine not being suitable for the use of the machine and not being
certified is forbidden.
Any manipulation of the machine and parts is forbidden.
The use of the machine for any purposes other than described in 12.1 is forbidden.
The unattended operation on the machine during the working process is forbidden!
It is not allowed to leave the immediate work area during the work is being performed.