Holzmann SM 100 User Manual - page 24
MAINTENANCE
HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at
Seite 24
SATINIERMASCHINE / BURNISHING MACHINE SM 100
15
MAINTENANCE
A T T E N T I O N
Don’t clean or do maintenance on the machine while it is still connected
to the power supply:
Damages to machine and injuries might occur due to unintended
switching on of the machine!
Therefore: Switch the machine off and disconnect it from the power
supply be-fore any maintenance works or cleaning is carried out
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all
connecting parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the saw band and the saw band guide.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
N O T I C E
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a
pre-requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
15.1
Maintenance plan
After each workshift: Remove chips and sanding dust from the device
After 10 hours of operation:
When working metal it is possible for conductive dust to settle in the interior of the power
tool. The total insulation of the power tool can be impaired. Blow out the interior of the
power tool via the ventilation slots with compressed air.