Holzmann SM 100 User Manual - page 23
OPERATION
HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at
Seite 23
SATINIERMASCHINE / BURNISHING MACHINE SM 100
14
OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
14.1
Operation instructions
W A R N I N G
Perform all machine settings with the machine being
disconnected from the power supply!
A T T E N T I O N
Please observe the following operating instructions so that their
work can be performed safely and has the expected success.
N O T I C E
Check before starting work:
All cables and plugs
The free and centered run of sanding belt
The sanding:
Always use the proper, located in perfect condition abrasives.
(Change wear of abrasives immediately!) With abrasive in good
condition you obtain a good grinding result.
Always guide the machine with both hands.
Do not exert too much pressure to the workpiece
14.2
Operation
On-Off-Switch:
Press the switch (1) to start the
machine. For continuous activation
press down the lock button (2) in
the meantime.
To switch off press the switch (1)
again.
Speed controll:
To adjust the speed, turn the speed-
controller (3).