I-Sotec i-soamp Manual manual - page 3
A INSTALLATION
When installing the equipment, be sure that it is well ventilated. It
must not be covered or mounted near heat emitting objects or be
subjected to direct sunlight.
The i-soamp Medialink can heat itself up significantly (up to 80°C); it is therefore
important to ensure sufficient clearance from other heat-sensitive vehicle compo-
nents (particulary plastic-parts and electronic components)!
For safety reasons, the device must be securely mounted in the vehicle. Attach
the device with the supplied mounting screws to a firm and suitable base. Do
not drill holes in parts of the vehicle if you are not sure what is located behind.
Watch out for wiring harnesses and fuel lines!!!
A.1.Accessorys
The i-soamp package includes the following accessorys:
1. Amplifier unit
2. Controller (Medialink only)
3. Wiring harness
4. Iso-power plug
5. Manual
A.1 Connection
The i-soamp or Auxgate is connec-
ted directly to the vehicle cable har-
ness and to the original radio with
an adaptor. Vehicle models without
an ISO connection require a special
vehicle-specific adaptor for this pur-
pose. Please consult the i-sotec vehi-
cle list to check whether you need
an additional adaptor to connect the
i-soamp to your vehicle. You can do
this online as well at http://www.i-
sotec.com/
A INSTALLATION
Achten Sie bei der Installation unbedingt auf eine gute Belüftung
des Gerätes. Es darf nicht abgedeckt oder in der Nähe anderer Wärme
abstrahlender Gegenstände montiert oder direkter Sonneneinstrahlung ausge-
setzt werden!
Die Geräte können sich selbst stark erwärmen (bis zu 80°C), daher ist auf aus-
reichenden Abstand zu anderen wärmeempfindlichen Fahrzeugteilen (insbe-
sondere Kunststoffteile und elektronische Komponenten) zu achten!
Aus Sicherheitsgründen muss das Gerät fest im Fahrzeug installiert werden.
Befestigen Sie das Gerät mit den mitgelieferten Montageschrauben an einem
festen und geeigneten Untergrund. Bohren Sie keine Löcher in Teile des
Fahrzeuges, wenn Sie nicht wissen, was sich dahinter befindet. Achten Sie auf
Kabelbäume und Benzinleitungen!
Lieferumfang
Die i-sotec Car-Audio-Systeme wer-
den mit folgendem Zubehör gelie-
fert:
1. Verstärkereinheit
2. Controller (nur Medialink)
3. i-sotec Kabelbaum
4. Iso-Stromadapter
5. Handbuch
A.1. ANSCHLUSS
Der i-soamp oder das Auxgate®
wird mittels original i-sotec
Adapter direkt an den Fahrzeug-
Kabelbaum und an das
Originalradio angeschlossen. Bei
Fahrzeugtypen ohne ISO Anschluss
wird hierfür zusätzlich ein fahr-
zeugspezifischer Adapter benötigt.
Überprüfen Sie bitte anhand der i-
sotec Fahrzeugliste, ob Sie zum
Anschluss des i-soamp an Ihrem
Fahrzeug einen zusätzlichen
Adapter benötigen. Sie können
dies auch online unter
http://www.i-sotec.com feststellen.
D
UK
manual_isoampML_AGConnect 30.01.2007 17:07 Uhr Seite 3