I-Sotec i-soamp Manual manual - page 9
selected a piece of metal that was only glued to the vehicle chassis.
The black cable is connected to the grounding point; make sure
there is a good electrical contact.
3. The red cable is connected to the positive terminal of the battery via
a suitable fuse.
CAUTION: A main fuse MUST be inserted into the positive cable a maximum of
12"’ (=30cm) distance from the positive battery post (insurance company requi-
rement!). This fuse will blow in the event of mechanical damage to the cable and
conductor contact with the chassis to prevent a cable fire or worse! The rating
must be appropriate for the total current input of the system. The fuse in the
device wiring harness protects only the device itself, but not the battery and the
vehicle! Suitable fuse elements can be found in accessories stores.
4. After the power cable is properly connected, the battery can be reconnected.
5. The 2-pin power connector cable at the i-soamp cable harness (see photo, A)
is connected to power connector cable AD-0125 (B).
zeugchassis geklebt wurde. Das schwarze Kabel wird an dem Masse-
punkt angeschlossen, hierbei ist auf guten elektrischen Kontakt zu
achten.
3. Das rote Kabel wird über eine geeignete Sicherung am Pluspol der
Batterie angeschlossen.
Achtung: In das Plus-Kabel MUSS eine Hauptsicherung in maximal 30cm
Entfernung von der Plusklemme der Batterie eingefügt werden (Vorschrift der
Versicherungen!), die bei mechanischer Beschädigung des Kabels oder bei
Chassiskontakt der Stromleitung auslöst, um einen Kabelbrand oder
Schlimmeres zu verhindern! Der Wert muss an die gesamte Stromaufnahme der
Anlage angepasst sein. Die Sicherung im Kabelbaum des Gerätes schützt nur
das Gerät selbst, nicht aber die Batterie und das Fahrzeug!
4. Nach dem ordnungsgemäßen Anschluss der Stromkabel kann die Batterie
wieder angeklemmt werden.
5. Der zweipolige Stromanschlussstecker am i-soamp Kabelbaum (siehe Foto, A)
wird mit dem Stromanschlusskabel AD-0125 (B) verbunden.
B.1 Warnhinweise
Die Sicherung am Gerät darf nur mit dem gleichen Wert (20A) ersetzt wer-
den, um eine Beschädigung des Gerätes zu verhindern. Höhere Werte können
zu gefährlichen Folgeschäden führen!
Der i-soamp kann höhere Leistungen an die vorhandenen Lautsprecher abge-
ben als das Original-Radio. Die meisten Lautsprecher können diese problemlos
verkraften. Bitte gehen Sie dennoch vorsichtig mit dem Lautstärkeregler um.
Vermeiden Sie langzeitige, überhöhte Lautstärken, die sich durch einen unan-
genehmen verzerrten Klang bemerkbar machen, um eine Beschädigung der
Lautsprecher zu verhindern.
Es wird empfohlen, die Klangregler (Bässe /Höhen) des Autoradios auf
„Neutral“, also in Mittelstellung, bzw. „0“, einzustellen. So stellt sich erfah-
rungsgemäß der beste und natürlichste Klangeindruck ein; eine Überlastung
der Lautsprecher wird vermieden.
B.2 Technische Daten
Betriebsspannung: 10,4-14,4V DC
Strombedarf: Max. 15A
Musik Leistung Medialink: 4x 70W @ 4 Ohm bzw. 2x70W+1x110W @ 4 Ohm
Musik Leistung Auxgate® Connect: 4 x 35 W @ 4 Ohm
Lautsprecher Impedanz:: Min. 4 Ohm
THD+N: <0,01%
SNR: >96dB
Max. Umgebungstemperatur: 45°C
Abmessungen i-soamp Mediallink (LxHxB): 200 mm x 48 mm x 156 m
Abmessungen Auxgate® (LxHxB): 136 x 43 x 100 mm
Schutzfunktionen:
• Unterspannung (low Batt., LED-GELB): Abschaltung bei <10,2V, wieder
Einschaltung bei >11,4V
• Übertemperatur (Temp., LED-ROT): Abschaltung bei >80°C, wieder
Einschaltung bei <70°C
Gewährleistung 24 Monate
D
UK
B.1 Caution notice:
The fuse for the device may only be replaced with a fuse of the same rating
(20A) to avoid damage to the device. Higher value fuses can result in dangerous
consequences!!!
The i-soamp can deliver higher output to the existing loudspeakers than the ori-
ginal radio. Most loudspeakers can handle it with no problem. Nevertheless,
please be very careful with the volume control. To prevent damage to the loud-
speakers, avoid leaving the volume up too high for long periods, which is notice-
able by an unpleasant, distorted sound.
It is highly recommended to set the car radio's tone controls (basses/trebles) to
"neutral", i.e. to the center point and/or "0". Experience has shown that this is the
best setting for the best and most natural sound and avoids overloading the
speakers.
B.2 TECHNICAL DATA
Operating voltage: 10 ,4-14,4V DC
Required power:
Max. 15A
Music output Medialink: 4 x 70W @ 4 Ohm and/or2x70 + 1x110W @ 4 Ohm
Music output Auxgate®: 4x35 W @4 Ohm
Loudspeaker impedance:
Min. 4 Ohm
THD+N: <0.01%
SNR:
>96dB
Max. ambient temperature:
45°C
Dimensions Medialink (LxHxW): 200 mm x 48 mm x 156 m
Dimensions Auxgate® (LxHxW): 136 x 43 x 100 mm
Protective features:
• Undervoltage (low batt., LED-YELLOW): switches off at <10,2V, switches on
again at >11,4V
• Excessive temperature (temp., LED-RED): switches off at >80°C, switches on
again at <70°C
24 months Limited Warranty
manual_isoampML_AGConnect 30.01.2007 17:07 Uhr Seite 9