IC Realtime PTZ2300SIR User Manual - page 19
13
PRESET NO :001
TITLE :PRESET1
SETTING
CALL
BACK EXIT
Please go back to main menu and move the cursor to FUNCTION SETTING, click confirm button. You
can see the above interface.
z
PRESET: It is to set preset. Move the cursor to PRESET and then click confirm button to go to the
third submenu.
z
AUTO PAN: It is to set pan. Move the cursor to AUTO PAN and then click confirm button to go to
the third submenu.
z
AUTO SCAN: It is to set scan number, speed and etc. Move the cursor to AUTO SCAN and then
click confirm button to go to the third submenu.
z
AUTO TOUR: It is to set tour number, tour operation and etc. Move the cursor to AUTO TOUR and
then click confirm button to go to the third submenu.
z
AUTO PATTERN: It is to set pattern number and etc. Move the cursor to AUTO PATTERN and then
click confirm button to go to the third submenu.
z
IDLE MOTION: It is to set idle operation, idle time and etc. Move the cursor to IDLE MOTION and
then click confirm button to go to the third submenu.
z
TIME TASK: It is to set system schedule operation. Move the cursor to TIME TASK and then click
confirm button to go to the third submenu.
z
NEXT PAGE: It includes: PRIVACY MASK, PTZ SPEED, SET ZERO, POWER UP and etc. Move
the cursor to the item and then click the confirm button to set.
z
BACK: Go back to previous menu.
z
EXIT: Log out system menu.
3.4.4.1 Preset Setup
Move the cursor to PRESET button and then click confirm button to go to set interface.
z
PRESET NO: Please use left/right key to modify preset number. The different protocols support
different preset values.
z
TITLE:Title text is the label used for you to identify the camera. System will automatically name a
title for the camera.
z
SETTING: Please input preset number first and then select the monitor zone. Please move the
cursor to setting and click confirm button. The system will pop up a message: PRESET: ***. Here ***
means preset number. And the SETTING column pops up an OK. Now you successfully added a
preset. Please note, you need to enable display preset title function first (Main menu->display
setting->preset title).Repeat the above procedures to set more presets. Once you want to modify a
preset, you can input the preset number you want to modify and then follow the above steps to set
the preset. You can successfully modify a preset content.
z
CALL: Here is to call preset. Move the cursor to PRESET NO and then input corresponding preset
value. Then move the cursor to CALL and then click confirm button to go to a preset.
z
BACK: Go back to previous menu.
z
EXIT: Log out system menu.
For PELCO protocol user, please refer to the following special functions: