IC Realtime PTZ2300SIR User Manual - page 22
16
IDLE MOTION
:
OFF
IDLE TIME
:
10MIN
IDLE MOTION :NONE
PARAMETER :NONE
BACK EXIT
TASK NO
:1
TIME TASK :OFF
TASK SETTING
TASK INFORMATION
DELETE TASK
BACK EXIT
z
CALL:Here is to activate pattern. Input pattern number, move the cursor to CALL and click confirm
button, system begins running pattern.
z
STOP: Here is to stop current pattern. Input pattern number, move the cursor to STOP and click
confirm button. System stops current pattern.
z
BACK: Go back to previous menu.
z
EXIT: Log out system menu.
Note:
z
The dwell time between two orders should be less than one minute, otherwise system will set to
default value as one minute.
z
After click PROGRAMSTOP, do not click CALL button before icon
“●” disappears completely.
z
Any manual operation during the pattern procedure will terminate current dome pattern operation.
3.4.4.6 Idle Motion
When there is no available command for specified time, dome automatically goes on the previous set
functions.
z
IDLE
MOTION:There are two modes ON/OFF. Please use left/right key to set.
z
IDLE TIME: System idle period. Please use the left/right button on the keyboard or in the speed
dome terminal menu to set.
z
IDLE MOTION:There are several functions you can select:
NONE/PRESET/SCAN/TOUR/PATTERN. Please use the left/right button on the keyboard or in the
speed dome terminal menu to set.
z
PARAMETER: It is to set idle motion SN. System can implement the corresponding action when it is
idle for the specified period. Click the left/right button to set.
z
SAVE:Move the cursor to SAVE and click confirm button to save current setup.
z
BACK: Go back to previous menu.
z
EXIT: Log out system menu.
3.4.4.7 Time Task (Schedule task)
• TASK NO: Here you can set task number. Please use the left’/right button to set.
• TIME TASK: The schedule task allows the speed dome to implement corresponding setup during
the specified time. There are two options: on/off. Please use the left/right button on the keyboard
or in the speed dome terminal menu to set.
• TASK SETTING: Here you can set task time, operation, operation SN and etc. Please click the
confirm button to go to the fourth menu to set.