Intergraph Zx10 Ultra-Tower System Manual - page 2

Copyright

 2000 Intergraph Computer Systems.  All rights reserved.  This document contains information protected by

copyright, trade secret, and trademark law.  This document may not, in whole or in part, be reproduced in any form or

by any means, or be used to make any derivative work, without written consent from Intergraph Computer Systems.

Use, duplication, or disclosure by the United States Government is subject to restrictions as set forth in subdivision

(c)(1)(ii) of the rights in technical data and computer software clause at DFARS 252.227-7013.  Unpublished rights are

reserved under the copyright laws of the United States.

Intergraph Computer Systems, Huntsville AL 35894-0001

Notice

Information in this document is subject to change without notice and should not be considered a commitment by

Intergraph Computer Systems.  Intergraph Computer Systems shall not be liable for technical or editorial errors in, or

omissions from, this document.  Intergraph Computer Systems shall not be liable for incidental or consequential

damages resulting from the furnishing or use of this document.

All warranties given by Intergraph Computer Systems about equipment or software are set forth in your purchase

contract.  Nothing stated in, or implied by, this document or its contents shall be considered or deemed a modification

or amendment of such warranties.

Trademarks

Intergraph

 and the Intergraph logo are registered trademarks of Intergraph Corporation.  Zx

 and Ultra-Tower

 are

trademarks of Intergraph Computer Systems.  Intel

 and Pentium

 are registered trademarks of Intel Corporation.

ServerSet

 is a trademark of ServerWorks Corporation.  Microsoft

, Windows

, and Windows NT

 are registered

trademarks of Microsoft Corporation.  Other brands and product names are trademarks of their respective owners.

FCC/DOC Compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of

the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference when the

equipment is operated in a residential installation.  This equipment generates, uses, and can radiate radio frequency

energy.  If the equipment is not installed and used in accordance with the instructions, it may cause harmful

interference to radio communications.  However, there is no guarantee that interference will not occur in a particular

installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, try to correct the interference as follows:  reorient or relocate the affected device; increase

the separation between this equipment and the affected device; connect this equipment to an outlet on a circuit different

from the circuit to which the affected device is connected; consult a dealer or an experienced radio/television

technician for help.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigencies du Règlement sur le materiél brouilleur du Canada.