Intergraph Zx10 Ultra-Tower System Manual - Finishing Software Setup

12

To start the computer and go through Setup:

1.

Turn on power to the monitor.

2.

Turn on power to the base unit.  The system starts and the EULA displays.

3.

Read the terms of the EULA and then follow the instructions displayed to complete the Setup

process.  When prompted, enter the Product Identification Number.

NOTE

You must enter the Product Identification Number before you can continue Setup.

You cannot complete Setup if you do not enter this number.

When going through Setup:

♦

Do not let Setup auto-detect the system’s network controller.  After completing Setup, install

the network controller driver software from diskette.  See “Finishing Software Setup” for

instructions.

♦

If prompted to create an Emergency Repair Disk, do so.

♦

If prompted to enter a password for the Administrator account, do so.

♦

If you do not create a user account during Setup, press 

ENTER

 or select OK at the logon dialog

to log on to the operating system.

♦

You can use the C:\

I

386 directory when prompted for the location of the operating system’s

Setup files.  If you delete the 

I

386 directory from the system’s hard disk, you must have access

to an operating system CD to use the operating system’s Setup files.

After you complete Setup and restart the system, you can set up a user account and join a

workgroup or domain if needed.  See the operating system documentation and operating system

Help for more information on Setup, creating a user account, and joining a workgroup or domain.

Finishing Software Setup

After completing operating system Setup, you must take some additional steps to finish setting up

the system software.

Installing the Network Controller Driver

Setup completed without auto-detecting the system’s network controller.  To enable networking,

you must manually install the network controller driver software from diskette.

The network controller driver software is in a folder on the system’s driver CD.  First see the

README

.

TXT

 file for information on creating a driver diskette using the 

MAKEMS

.

BAT

 program.

Then see the 

MS

.

TXT

 file for information on installing the driver software using Network in the

operating system Control Panel.  Keep the driver diskette for use if you have to reinstall the

operating system.