Intergraph Zx10 Ultra-Tower System Manual - page 55

43

Removing and Replacing the Faceplate

WARNING

The system is always on when connected to AC power.  Before removing the

faceplate, disconnect the system’s power cord from its AC power outlet.

 WARNING Replace the faceplate before operating the system.  This ensures proper airflow

for cooling.

To remove the faceplate:

1.

Open the door and stow it in the base unit.  You cannot remove the faceplate if the door is

closed.  See Chapter 4, “Operating the System.”

2.

Remove both side panels.  See “Opening and Closing the Base Unit” in this chapter.

3.

Gently pry and release each of the tabs connecting the faceplate to both sides of the chassis.

CAUTION

Release the tabs with care.  Do not apply more pressure than necessary.

4.

Gently pull the faceplate away from the chassis.

Faceplate Tabs (4 each side)