Intermec EasyCoder 501XP Reference Manual
Other manuals for EasyCoder 501XP:
Installation Manual, User Manual, Supplementary Manual, User Manual, Installation Instructions Manual, Reference Manual, Install Manual, Installation & Operation Manual, Installation & Operation Manual, Service Manual
Manual is about: Bar Code Label Printers
of
8
1
Intermec EasyCoder 501 XP/601 XP
EasySet Bar Code Wand Setup
1. Connect the EasySet bar code wand to the
receptacle on the printer’s rear plate.
2. Read the appropriate bar code to set up the prin-
ter. Hold the wand like a pencil and move it
rather swiftly across the bar code.
3. When the bar code has been accepted, the prin-
ter emits a short beep and the Ready control
lamp on the printer’s front blinks briefly.
4. This sheet only contains a selection of setup
options. For information on how to produce your
own setup bar codes, please refer to the Inter-
mec Fingerprint 7.12 Reference Manual.
Serial Communication on ”uart1:”
Baudrate
1-960438-02 EasySet Bar Code Sheet for EasyCoder 501 XP/601 XP, Edition 3, September 1998
Connect here!