JDS Uniphase OLP-34 Operating Instructions Manual - 3 G
12
OLP-34/-35/-38
JDSU
3 G
ETTING
S
TARTED
Power supply
The following power sources can be used to operate the
OLP-3x:
• two 1.5 V dry batteries (Mignon AA size, alkaline type
recommended)
• two 1.2 V NiMH rechargeable batteries
(Mignon AA size)
• via the AC adapter
• via the USB control interface (only BN 2302/11/12/13)
Battery operation
Replacing batteries
The battery compartment is on the back of the
instrument.
1. Pull down the lid to open the battery compartment.
2. Fit new batteries or remove the used batteries and
replace them with fresh ones.
NOTICE:
Take care to insert the batteries correctly. The
correct polarity is indicated by a diagram
inside the battery compartment.
3. Close the battery compartment.
4. Press
[
*
]
to switch on.
Note:
The batteries can not be recharged with the OLP-3x.
CAUTION
Dangers when handling batteries
Handling batteries may be dangerous.
Please note the following safety
instructions.
!
Please note the battery operation safety information in
the chapter
„Battery operation”, page 7
.
Replacing batteries
!
Do not replace individual batteries. Always change all
two batteries at the same time.
!
Always use two batteries of the same type; i.e. do not
mix rechargeable and non-rechargeable batteries.