JDS Uniphase OLP-34 Operating Instructions Manual - 5 M
22
OLP-34/-35/-38
JDSU
5 M
EMORY
M
ANAGEMENT
Store measurements
To save the current measurement result:
1. Press
[STORE]
to save the current result.
The result is saved and the related memory location is
shown in the upper left corner of the display for a short
time, e.g. “MEM 2.”
Note:
The new results are always appended
successively at the last memory location, even if
you clear a previously assigned memory location
with a lower number.
Recall measurements
To recall stored measurement results:
1. Press
[RECALL]
and hold it for at least 2 seconds.
The device is in recall mode and the latest stored
memory location is shown in the upper left corner of
the display.
2. Use
[
]
to browse through the stored memory
locations.
3. Press
[RECALL]
again to exit the recall mode.
Delete measurements
To delete a stored measurement result:
The device is in recall mode.
1. Use
[
]
to select the memory location to be deleted.
2. Press
[CLR]
and hold it for at least 2 seconds.
The selected memory location is deleted and the
display shows 4 bars.
Note:
It is not possible to select and overwrite empty
memory locations.