JDS Uniphase OLP-34 Operating Instructions Manual - 4 O
18
OLP-34/-35/-38
JDSU
4 O
PERATION
Editing the wavelength table
The wavelength table supports the definition of 5
wavelengths.
To edit the wavelenght table:
1. Press
[
λ
]
to select a wavelength (1 to 5).
2. Press and hold down
[SET]
for more than 2 sec.
The wavelength table is in the edit mode.
3. Use
[
]
to change the wavelength value.
- Press once to change one step at a time.
- Hold down the key to increase the step change rate.
4. Press
[SET]
to save the new wavelength.
Displaying absolute power level
The power level is displayed in dBm or Watts (nW, µW,
mW) in absolute power level display mode.
Press
[dBm/W]
to display absolute power level and to
toggle between dBm or Watts.
Fig. 4 Displaying absolute power level in dBm.
Power level ranges
Tester
dBm
Watt
BN 2302/01/11 -60 to +10 dBm 1 nW to 10 mW
BN 2302/02/12 -65 to +10 dBm 1 nW to 10 mW
BN 2302/03/13 -50 to +26 dBm 10 nW to 400 mW