JDS Uniphase OLP-34 Operating Instructions Manual - 4 O
Manual is about: Optical Power Meter
of
86
JDSU
OLP-34/-35/-38
17
4 O
PERATION
Selecting a wavelength
The sensitivity of the photo diode depends on the
wavelength. The wavelength setting of the device must
match the wavelength of the incoming signal to ensure a
correct reading.
To select a wavelength:
Press
[
λ
]
to select a new wavelength.
The value is shown in the lower right display:
The wavelengths that can be selected by pressing this
key are an extract of those contained in the internal
wavelength table.
Fig. 3 Wavelength entries
Wavelength 1
Wavelength 2
Wavelength 3
Wavelength 4
Wavelength 5