Jeep Grand Cherokee Quick Reference Manual - page 13
To Set A Memory Position:
1. Cycle the vehicle’s ignition to the ON/RUN
position (Do not start the engine).
2. Adjust all memory profile settings.
3. Push and release the S (Set) button.
4. Push and release the 1 or 2 button within
five seconds.
NOTE:
To Program A Key Fob To The Memory Position:
1. Cycle the vehicle’s ignition to the OFF posi-
tion.
2. Select the desired memory profile, 1 or 2.
3. Push and release the S (SET) button on the
memory switch, then within five seconds,
press and release the 1 or 2 button accord-
ingly.
4. Push and release the lock button on the key
fob within 10 seconds.
NOTE:
Memory seats can be programmed/stored while
the engine is running.
For further information and applicable warn-
ings and cautions, please refer to your Owner’s
Manual at www.jeep.com/en/owners/manuals.
Wiper/Washer Controls
The multifunction lever is located on the left
side of the steering column.
Front Wiper Operation
The front wipers are operated by rotating a
switch, located on the end of the lever.
Rear Wiper Operation
The rear wiper/washer is operated by rotating a
switch, located on the middle of the lever.
Multifunction Lever
WINDSHIELD WIPER/WASHER
FEATURES