Kuschall K-SERIES Service Manual - page 13
13
KÜSCHALL K-SERIES
attract
© Küschall AG, Switzerland | 2014-12
Service Manual
BACKREST
Backrest height (RH)
The height of the backrest can be adjusted by moving the backrest
tube.
Adjusting the backrest height
Readjusting the push handle/telescopic tube
Difficulty:
Tools:
à 3,
8
Remove the backrest padding.
Remove the screw connection A and adjust the desired height of
the push handle or the telescopic tube. Insert the screw
connection A again and tighten the nut.
Carry out the same setting on both sides.
Refit the backrest padding.
i
If the desired height cannot be achieved, you must use a different
telescopic tube or push handle.
Securing/adjusting the release cord
Difficulty:
WARNING!
Risk of injury to the user during use as a result of the backrest
folding over unintentionally.
If the release cord is too taut, the locking mechanism B can
open unintentionally.
Make sure that the release cord is not too taut.
Knot the release cord A, left and right, to the wire rings C
such that it is free from tension, but still ensuring that there is
only minimal slack (
A
à 7 Nm