Kuschall K-SERIES Service Manual - page 17
17
KÜSCHALL K-SERIES
attract
© Küschall AG, Switzerland | 2014-12
Service Manual
FOOTRESTS
FOOTRESTS
The footrest must be selected in accordance with the seat width.
A standard footrest and an angle-adjustable footrest are available.
Lower leg length (UL)
To change the lower leg length, the footrest can be fixed at a high-
er or lower position.
Table, Chap. Frame. The shortest lower leg
lengths can be achieved using the high-mounted footrest.
‹Fitting
and adjusting high-mounted footrest›
Replacing footrests
Difficulty:
Tools:
à 4,
8
Remove the screw connections A on both sides.
Remove the footrest and replace it with a new one.
Tighten the screw connections A on both sides.
Carry out the same setting on both sides.
Adjusting the footrest height
Difficulty:
Tools:
à 4,
8
The height of the footrest can be adjusted in 10 mm steps.
Remove the screw connections A on both sides.
Slide the footplate to the desired height.
Tighten the screw connections A on both sides.
Carry out the same setting on both sides.
Angle-adjustable footplate, adjusting the
angle
Difficulty:
Tools:
à 4,
10
To adjust the angle, release the four screw connections A until
the footplate can be moved.
Check and/or adjust the distance between the left and the right
sides by pushing in or pulling out the tubes below the footplate
in such a way that the bearings blocks are perpendicular to the
ground.
Tilt the footplate into the desired position and tighten the screw
connections A.
The angle of the footplate must be set so that the user’s feet
cannot slide off the plate.
Make sure that the footplate has a minimum distance of 20 mm to
the floor at its lowest point.
A
à 4 Nm
A
à 4 Nm
A
à 13 Nm