Kuschall K-SERIES Service Manual - page 9
9
KÜSCHALL K-SERIES
attract
© Küschall AG, Switzerland | 2014-12
Service Manual
SEAT
If the rear wheel, front wheel and front wheel fork are defined, the
front seat height can be adjusted by changing the position of the seat
module within the frame. There is 1 bracket available with 8 fixing
options.
Positioning or replacing the brackets at the front for
setting the front seat height (SHv)
Difficulty:
Tools:
à 4, 5
Remove the rear wheels, fold the backrest forward and place the
wheelchair on its back.
Remove all screws on one side that hold the seat cover to remove
tension.
Loosen the screws A and B that connect the seat brace C to the
seat module or the frame on both sides.
Remove the screw E and place it in the bracket’s D other hole.
Refit the rear wheels, stand the wheelchair back
up and check the position of the seat braces C.
They must be as perpendicular to the ground as
possible.
Reattach the seat cover and tighten the screws.
Tighten the screw connections A and B of the
seat braces and E and F of the front brackets
again.
Carry out the same setting on both sides.
i
Note: ensure that adjusting the front seat height
results in a change to the seat angle. It may be
necessary to correspondingly adjust the rear seat
height (SHh) or the backrest angle.
1
2
3
4
5
6
7
8
A
à7 Nm
B
à13 Nm
E
à7 Nm
F
à7 Nm