Kuschall K-SERIES Service Manual - page 23
23
KÜSCHALL K-SERIES
attract
© Küschall AG, Switzerland | 2014-12
Service Manual
REAR WHEELS
REAR WHEELS
Ensuring the rear wheels are parallel
Difficulty:
Tools:
à 5
Loosen the screws A on both clamp sets. Rotate the axle tube to
set the correct position.
Tighten the screw A on both sides.
i
This setting must be carried out on a horizontal surface. The track
of the rear wheels is correct if the distance between the rear
wheels is the same at the front and the back (x=y) – measured at
the height of the centre of the axle.
Adjusting the removable axle
Difficulty:
Tools:
11, 19
Remove the rear wheel.
Hold the end of the removable axle
B
using the straddle
spanner.
Adjust the length L of the removable axle by turning the nut
A.
The length is correctly adjusted if the removable axle engages
correctly when fixing the wheel and wheel has just minimal
clearance.
i
The wheels must be exchanged (left to right side and vice versa)
after adjusting both removable axles. The adjustment must now
be checked or carried out again to ensure the wheels can be
switched.
Changing the wheel chamber
Standard axle
Difficulty:
Tools:
à 5
A new axle must be used to change the wheel chamber.
Remove the screws A on both sides and remove the lower part
of the axle holder B.
Replace the axle C with a new axle with the desired wheel
chamber.
Attach the lower part of the axle holder B on both sides and
insert the screw A.
Ensure the rear wheels are parallel,
Ensuring the rear wheels are parallel.
Tighten the screws A on both sides.
x
y
A
à 13 Nm
L
A
B
A
à 13 Nm