Kuschall K-SERIES Service Manual - page 25
25
KÜSCHALL K-SERIES
attract
© Küschall AG, Switzerland | 2014-12
Service Manual
OPTIONS & ACCESSORIES
OPTIONS & ACCESSORIES
Antitipper
There are two different sizes of antitipper for both the left and the
right sides.
Fit antitipper without rear wheel extension
Difficulty:
Tools:
à 3, 5
8
Loosen the screws A and and remove the lower part of the axle
holder B.
Fix the adaptation holder clip C with screws A.
Check that the rear wheels are parallel,
Chap. Rear wheels; Ensuring the rear wheels are parallel.
Fix the antitipper to the adaptation holder C using screws D.
Measure the distance between the antitipper and the ground,
Adjusting the height of the antitipper.
Adjusting the length of the antitipper
Difficulty:
Tools:
à 3, 5,
8
Press the adjustment button
E
on the antitipper and pull the
antitip tube into the desired position. Let the adjustment button
latch into the adjacent hole.
Function check:
The distance between the antitipper and the ground must be
40 - 60 mm. It must be easy to fold up the antitipper.
Tip the wheelchair backwards using the antitipper until the axle is
perpendicular to the antitipper’s point of contact with the ground. In
this position, the distance between the rear wheel and the ground
must be at least 50 mm.
x
x 50 mm