Kuschall K-SERIES Service Manual - page 21
21
KÜSCHALL K-SERIES
attract
© Küschall AG, Switzerland | 2014-12
Service Manual
SIDE PARTS
Replacing the clothes-guard
The mounting element A on the backrest must already be fitted.
Difficulty:
Tools:
à 3, 4
If present, remove the clothes-guard to be replaced by
loosening the screw connection C.
Check the correct position of the clothes-guard B with fitted
rear wheel. Here, find the suitable height on the clothes-
guard B for fixing the screw connection C to the backrest
mount A.
If necessary, the holder D on the seat module can be replaced.
Here, remove the screw E.
i
The clothes-guard is correctly positioned if it can be inserted
between the seat module and the holder and the upper edge
runs above the rear wheel.
Fitting the mudguard
Difficulty:
Tools:
à 3, 4,
10 Ò 2
Remove the clothes-guard and the mounting elements on the back-
rest and the seat.
Fit the holder to the seat module using the screw connections A
and then refit the rear wheel.
Slightly loosen the screws B on the adjustment plate and slide
it along the mudguard carrier until the mudguard is at the right
height.
The position of the mudguard can also be adjusted: Here, loosen
the screw connections C and D, position the mudguard as
required and tighten the screw connections C and D again.
Tighten the screws B again.
Carry out the same setting on both sides.
By tightening or loosening the screws E you can adjust how easily
the armrest can be pulled out or pushed in.
i
If the wheelchair is equipped with a suspension, the distance
between the mudguard and the wheel must be at least 40 mm.
i
The existing axle may not be sufficiently long for the new
configuration with mudguard. In this case, a longer axle must be
fitted.
Changing the wheel chamber / fitting and adjusting an
axle
The distance between the mudguard and the wheel must be
either 25 mm to prevent fingers from becoming
caught between the wheel and the mudguard.
C
à 4 Nm
E
à 7 Nm
F
à 4 Nm
A
à 7 Nm
B
à 4 Nm
C
à 7 Nm
D
à 7 Nm