La Crosse Technology Wireless Weather Station Instruction Manual - page 3
9
batteries will need to be removed from all the units and reset from
step 1.
Note : User shall insert the batteries into the second transmitter
within 45 seconds after the Weather Station displays the
information of the first transmitter.
6.
Insert the batteries in the third transmitter as soon as the "channel
2" icon and outdoor data are displayed on the Weather Station.
Then within 2 minutes, the channel 3 outdoor data from the third
transmitter will be displayed and the channel icon will shift back to
"1" once the third transmitter is successfully received. If this is not
happen, user shall restart the setting up from step 1.
Note : User shall insert the batteries into the third transmitter within
45 seconds after the Weather Station displays the information of
the first transmitter. Or immediately after reception of the second
transmitter is finished.
7.
The distance between the Weather Station and the transmitter
should not be more than 300 feet to ensure sufficient 915 MHz
transmission. (see notes on “Positioning” and “915 MHz
Reception”).
10
IMPORTANT:
Transmission problems will arise if the setting for additional sensors is not
followed as described above. Should transmission problems occur, it is
necessary to remove the batteries from all units and start again the set-up
from step 1.
Note:
x
If the signal reception is not successful on the first frequency of
915MHz for 45 seconds, the frequency is changed to 920MHz and
the learning is tried for another 45 seconds. If it is still not
successful the reception is tried for 45 seconds on 910MHz. This
will also be done during re-synchronization.
x
When the weather station is receiving the WWVB time signal, the
outdoor transmitter data signal will temporarily not be received by
the weather station. During this short period of time, the outdoor
readings shown on the weather station will not be renewed until the
WWVB time signal is successfully received.
11
TO INSTALL AND REPLACE BATTERIES IN THE THERMO-
HYGRO TRANSMITTER
The Thermo-Hygro Transmitter uses 2 x AA, IEC, LR6,
1.5V batteries. To install and replace the batteries,
please follow the steps below:
1.
Remove the cover.
2.
Insert the batteries, observing the correct polarity
(see marking).
3.
Replace the battery cover.
Note:
In the event of changing batteries in any of the units, all units need to be
reset by following the setting up procedures. This is due to a random
security code assigned by the transmitter at start-up. This code must be
received and stored by the Weather Station in the first 3 minutes of power
being supplied to the transmitter.
TO INSTALL AND REPLACE BATTERIES IN THE WEATHER
STATION
The Weather Station uses 2 x C, IEC LR14, 1.5V batteries. To install and
replace the batteries, please follow the steps below:
12
1.
Insert finger or other solid object in the space at the bottom center
of the battery compartment and lift up to remove the cover.
2.
Insert batteries observing the correct polarity (see marking).
3.
Replace compartment cover.
BATTERY CHANGE:
It is recommended to replace the batteries in all units on an annual basis
to ensure optimum accuracy of these units.