La Crosse Technology Wireless Weather Station Instruction Manual - page 5
17
x
Increase, change, toggle all values in manual set mode
x
Press to set the alarm minute (inside alarm setting mode)
x
Stop the alarm during alarm ringing
x
Stop snooze mode
SNOOZE/CH key
x
Active snooze function during alarm ringing
x
Exit the manual set mode and alarm setting mode
x
Switch among display of channels (if more than 1 transmitter is
used)
LCD SCREEN
The LCD screen is split into 4 sections displaying the information for
time/calendar/alarm/moon phase, indoor data, weather forecast and
outdoor data.
18
Moon phase
icon
Weather
tendency
indicator
Time
Calendar
or alarm
time
Indoor relative
humidity in
RH%
Time reception icon
(for WWVB time)
Indoor
temperature
in °F/°C
Weather
forecast
icon
Outdoor data
signal reception
indicator*
Outdoor
temperature in
°F/°C
Outdoor
relative
humidity in
RH%
Comfort
indicator icon
Relative air
pressure history
Relative air
pressure in
hPa / inHg
Alarm icon
Remote transmitter
number (if more than 1
transmitter is used)
Low battery
indicator
19
* When the signal is successfully received by the Weather Station, the
outdoor transmission icon
will be switched on. If not successful, the
icon will not be shown on LCD. The user can then easily see whether the
last reception was successful (icon on) or not (icon off). A short blinking of
the icon indicates that signal reception is currently taking place.
MANUAL SETTINGS:
The following manual settings can be changed when pressing the SET
key:
x
LCD contrast setting
x
Time zone setting
x
DST ON/OFF setting
x
Time reception ON/OFF setting
x
12/24-hour format setting
x
Manual time setting
x
Calendar setting
x
°F/°C temperature setting
x
Air pressure setting (hPa / inHg)
x
Relative air pressure setting
x
Weather forecasting icon sensitivity setting
20
Note: SET mode is entered by pressing and holding the SET key for 3
seconds. If you do not press any keys for 15 seconds while in SET
mode, the Weather Station switches out of SET mode.
LCD CONTRAST SETTING:
The LCD contrast can be set within 8 levels, from LCD 0 to LCD7 (Default
setting is LCD 4):
1.
Press and hold the SET key until the digit starts flashing.
2.
Use the OUT/+ key to view all levels of contrast.
3.
Select the desired LCD contrast. Confirm with the SET key and
enter in the Time Zone setting.
TIME ZONE SETTING:
Flashing
Last digit flashing