Labrie expert 2000 Operator's Manual - Unloading The Body

47

Expert(t) 2000

TM

Operator Manual

Note:To put the floor riser back in 

its vertical position, apply the 

above procedure, from step 3 

to step 1.

Unloading the Body

When the body of the Expert(t) 2000

TM

is full, you proceed to unload it in the 

corresponding landfill. The unloading 

procedure recommended by Labrie 

helps you carry out this operation in a 

timely and safely manner.

To unload the body:

1.

Drive the vehicle to the desired 

dumping site.

2.

Make sure the vehicle is on safe, 

stable and level ground.

3.

Apply the parking brake, get off 

the cab and remove the tailgate 

safety pins.

4.

Back in the cab, use the lever on 

the console to fully open the 

tailgate.

Figure 36. Unloading the Expert(t) 

2000

TM

5.

Raise the body. Waste starts to 

slide out as the body raises.

Tip: You can throttle to rev up 

the engine and speed up 

WARNING

A

LWAYS

CHECK

FOR

OVERHEAD

CLEARANCE

BEFORE

OPENING

THE

TAILGATE

AND

LIFTING

THE

BODY

.

Body control 

lever

Pull up the 

yellow lock, 

then move 

the lever 

sideways to 

either raise 

or lower the 

body. 

Tailgate control lever

Pull up the 

yellow lock, 

then move 

the lever 

sideways to 

either raise 

or lower the 

tailgate.