LaCie Rugged Hard Disk User Manual - page 18
user manual | page 18
3.2. Disconnecting Your LaCie Drive
FireWire and USB external devices feature “plug & play” connectivity, which means that your drive can be connected and
disconnected while the computer is running. To prevent failures, it is important you follow these steps when disconnecting your
FireWire or USB peripheral device.
Warning:
Do not disconnect the USB or FireWire cable when the drive is reading or writing. Disconnecting while the
drive is operating could cause the loss of data. Make sure that your drive is not reading or writing and that the activity
LED is off before disconnecting the USB or FireWire cable.
Windows Users
From the System Tray (located in the lower right-hand side of your screen), click on the
Eject
icon (a small green
arrow over a hardware image).
A message will appear, detailing the devices that the
Eject
icon controls, i.e. “Safely remove…” Click on this prompt.
You will then be given the following message: “Safe to Remove Hardware” (or similar). It is now safe to disconnect the
device.
Mac Users
You must unmount the hard drive system before disconnecting it or powering it down. Either:
• Drag the hard drive icon to the trash.
• Launch
Silverlining Pro
, highlight the hard drive and select “Unmount.”
The drive can now be disconnected.
3. Installing Your LaCie Drive
Mac OS 10.x
Mac OS 9.x
1
2
3