Lancia Musa Owner's Handbook Manual - page 146
145
W
A
RNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
ST
AR
TING
AND DRIVING
IN AN
EMERGENCY
fig. 11
L0D0397m
fig. 12
L0D0163m
❒ for cars fitting alloy rims, remove
the hub cap using the screwdriver
provided levering in groove E-
fig. 11, as shown in the figure;
❒ loosen the bolts of the wheel to be
replaced by about one turn with the
wrench provided E-fig. 12; if the
car is fitted with alloy rims, shake
the car to facilitate removing the
rim from the wheel hub;
❒ operate the device F- fig. 13 to ex-
pand the jack, until the groove G
on the upper part of the jack is
correctly inserted on the lower
edge H of the body at indication
I (at approximately 60 cm from
the front wheel centre or 80 cm
from the rear wheel centre);
❒ warn anybody nearby that the car
is about to be lifted. They must
stay clear and not touch the car
until it is back on the ground;
❒ fit the handle L-fig. 13 to operate
the jack and lift the car until the
wheel to be changed is several cen-
timetres off the ground;
❒ for versions with wheel cap, remove
the wheel cap after loosening the
three fastening bolts and finally
loosen the fourth bolt and extract
the wheel;
❒ for versions with snap fitted wheel
cup, remove the cup being careful
not to damage it;
❒ make sure the contact surfaces be-
tween space saver spare wheel and
hub are clean so that the fastening
bolts will not come loose;
L0D0164m
fig. 13