Lancia Musa Owner's Handbook Manual - page 148
147
W
A
RNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
ST
AR
TING
AND DRIVING
IN AN
EMERGENCY
Versions with alloy rims
❒ Check that the hub contact sur-
faces are clean;
❒ fit the normal wheel centring it on
the pins, lead in the fastening
screws and tighten them using the
wrench provided;
❒ lower the car and remove the jack;
❒ using the wrench provided, fully
tighten the bolts in the sequence
shown in fig. 15.
❒ snap fit the wheel cup on the hub.
When you have finished
❒ stow the spare wheel in the space
provided in the boot;
❒ fit the jack partially open in its
box forcing it lightly to prevent it
from vibrating when travelling;
❒ put the tools back into their places
in the container;
❒ arrange the container and tools in
the spare wheel and secure the fas-
tening device;
❒ rearrange the preformed boot
cover correctly.
WHEN NEEDING
TO CHANGE A
BULB
GENERAL INSTRUCTIONS
❒ When a bulb is not working, check
that the corresponding fuse is in-
tact before replacing it: refer to the
“If a fuse blows” paragraph in this
chapter for fuse location.
❒ before changing a bulb check the
contacts for oxidation;
❒ burnt bulbs must be replaced by
others of the same type and power;
❒ always check the height of the
headlight beam after changing a
bulb.
Halogen lamps must be
handled holding the metal-
lic part only. Touching the
transparent part of the bulb
with your fingers may reduce the in-
tensity of the emitted light and even
compromise duration of the lamp it-
self.