Lancia Musa Owner's Handbook Manual - page 30
29
SAFETY
ST
AR
TING
AND DRIVING
W
A
RNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
Adjusting the automatic
headlight sensor sensitivity
(light sensor)
(for versions/markets, where provided)
This function is used to adjust the
dusk sensor sensitivity to three levels
(level 1 = minimum, level 2 =
medium, level 3 = maximum); higher
the sensitivity, lower the quantity of
external light needed to switch the
headlights on. The device is set to
level “2” when the car is delivered.
Proceed as follows to set:
– briefly press button MODE, the pre-
viously set level will flash on the dis-
play;
– press button + or – for setting;
– briefly press button MODE to go
back to the menu screen or hold the
button pressed to go back to the stan-
dard screen without storing the set-
tings.
Turning Trip B on/off (Trip B)
This function may be used to activate
(On) or deactivate (Off) the Trip B
(partial trip).
For further information see “Trip
computer”.
Proceed as follows to turn on and off:
– briefly pressMODE ON or OFF
flashes on the display (according to
the previous setting);
– press button + or – for setting;
– briefly press button MODE to go
back to the menu screen or hold the
button pressed to go back to the stan-
dard screen without storing the set-
tings.
Setting the clock
(Set clock)
This function is used to set the clock.
To carry out the adjustment, proceed
as follows:
– briefly press button MODE: the
“hours” will flash on the display;
– press button + or – to set;
– briefly press button MODE: “min-
utes” will start flashing on the display;
– press button + or – to set;
NOTE The setting will increase or de-
crease by one unit each time + or – is
pressed. Hold the button pressed to
increase/decrease the setting rapidly.
Complete the setting by briefly press-
ing the button when you approach the
required setting.
– briefly press button MODE to go
back to the menu screen or hold the
button pressed to go back to the stan-
dard screen without storing the set-
tings.