Lancia Musa Owner's Handbook Manual - page 29
28
SAFETY
ST
AR
TING
AND DRIVING
W
A
RNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
Speed limit
This function is used to set the car
speed limit (km/h or mph); the driver
is immediately alerted when this limit
is exceeded (see section “Warning
lights and messages”).
To set the desired speed limit, proceed
as follows:
– briefly press MODE, the message
(speed limit) will appear on the dis-
play.
– press button + or – to select speed
limit activation (On) or deactivation
(Off);
To cancel the setting, proceed as fol-
lows:
– briefly press button MODE: (On)
will flash on the display;
– press button +: (Off) will flash on
the display;
– briefly press button MODE to go
back to the menu screen or hold the
button pressed to go back to the stan-
dard screen without storing the settings.
– if the function has been activated
(On), press buttons + or – to select the
required speed limit and then press
MODE to confirm.
NOTE The speed may be set in the
range from 30 to 250 km/h, or from
20 to 155 mph according to the pre-
viously chosen unit (see “Setting the
distance unit”) described below. The
setting will increase/decrease by five
units each time button + / –
is
pressed. Hold button + / – pressed to
increase/decrease the setting rapidly.
Complete the setting by briefly press-
ing the button when you approach the
required setting.
– briefly press button MODE to go
back to the menu screen or hold the
button pressed to go back to the stan-
dard screen without storing the set-
tings.