Lancia Musa Owner's Handbook Manual - page 147
146
W
A
RNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
ST
AR
TING
AND DRIVING
IN AN
EMERGENCY
fig. 14
L0D0165m
fig. 15
L0D0166m
❒ fit the space saver spare wheel
making the holes M-fig. 14 coin-
cide with the corresponding cen-
tring pins N;
❒ using the wrench provided, tighten
the fastening bolts;
❒ turn the jack handle to lower the
car and remove the jack;
❒ use the wrench provided to fasten
the bolts completely in a criss-cross
fashion as shown in figure.
REFITTING THE
STANDARD WHEEL
Following the procedure described
previously, raise the car and remove
the space saver spare wheel.
Versions with steel rims
Proceed as follows:
❒ Make sure the contact surfaces be-
tween standard wheel and hub are
clean so that the fastening bolts
will not come loose.
❒ Fit the standard wheel by inserting
the first bolt for two threads into
the hole closest to the inflation
valve.
❒ Fit the wheel cup making the
groove (on the cup) coincide with
the inflation valve and then insert
the other three bolts.
❒ For models with snap-on wheel
cup, press the edge of the cup with
the palm of your hands against the
wheel (do not hammer).
❒ Using the wrench provided,
tighten the fastening bolts.
❒ Lower the car and remove the
jack.
❒ using the wrench provided, fully
tighten the bolts in the sequence
shown previously in figure fig. 15.
IMPORTANT Incorrect assembly may
cause the cup to come off while trav-
elling.