Lanier 5484 Operator's Manual - User Codes

Copying

70

2

User Codes

If the User Code function is turned on, operators must input their user codes be-

fore the machine can be operated. The machine keeps count of the number of

copies made under each user code.

Note

❒ When the machine is set for user codes, the machine will prompt you for your

user codes after the operation switch is on or the Auto Reset feature comes

into effect.

❒ You can adjust how long the machine waits before switching to the user code

input display. See “Copy Reset Timer” 

⇒

 P.312 “General Features”.

❒ To prevent others from making copies using your user code, press the {

Clear

Modes

} and {

Clear

} keys simultaneously after copying.

❒ You can turn User Codes on or off with the master unit System Settings. See

“User Codes:Copier/Document Server” in the System Settings manual.

❒ You can monitor the total number of copies mode by the master unit and sub-

unit with the master unit User Codes function.

❒ If User Codes are set on in the sub-unit and a code has been entered before

Connect Copy was selected, the master unit cannot monitor the number of

copies mode.

❒ If User Codes are set only in the sub-unit, you can enter Connect Copy mode

and make copies without entering a code. In this case the number of copies

mode will not be monitored.

Reference

For how to set up user codes, see “Settings You Can Change With The User

Tools” in the System Settings manual.

For how to register, change and delete user codes, see “Program/Change/

Delete User Code” 

⇒

 P.331 “Key Operator Tools”.

Auto Start

If you press the {

Start

} key during the warm-up period, the {

Start

} key will blink

and your copies will be made as soon as the warm-up finishes.

Note

❒ Copying will start if “Ready” is displayed on the master unit in Connect Copy

mode.

A

Make any adjustments to copy settings during the warm-up period.

B

Set your originals.