Lanier JP1030 Operator's Manual - page 106

Troubleshooting

94

5

Dirt on the Front Side of Paper (Black Line/Stain)

Note

❒ If there is no margin or if there is a solid image area near the leading edge of

the original, make a margin of at least 5mm, 0.2" at the leading edge. Other-

wise, the paper exit pawl might become dirty and cause black lines on prints.

❒ Check the exposure glass cover and clean it if dirty. See p.103 “Exposure

Glass Cover”.

❒ Check the exposure glass and clean it if dirty. See p.103 “Exposure Glass”.

❒ When black lines or stains still appear on prints even if you clean the above,

contact your service representative.

White Prints or Incomplete Prints

• Make sure that the paper feed side plates touch the paper lightly. Shift the

lock lever backward.

• When you use the optional document feeder, make sure that the original

guides contact the originals lightly.

GRBLAC1E

GRWHIT0E

TSLY015E

PinkGold-F_V4_FM.book  Page 94  Tuesday, September 11, 2001  6:31 PM