Lanier JP1030 Operator's Manual - Printing Problems
Printing Problems
73
5
Printing Problems
Combining Originals Mode
Problem
Cause
Action
When you try to set several
functions at a time, you can-
not set some functions.
Some functions cannot be
used together.
⇒ p.105 “Combination Chart”
Parts of the image are not
printed in Edge Erase mode.
Erase margin is too wide.
Set a narrower erase margin
with the service program.
⇒
p.57 “User Tools Menu”
Edge margins of original are
too narrow.
Prints are blank or parts of the
image are not printed.
The paper feed side plates are
not set correctly.
Make sure that the paper feed
side plates touch the paper
lightly.
2nd printing with another
drum is unsatisfactory.
The 1st print image is still wet. Wait until the 1st image be-
comes dry.
An uneven solid image ap-
pears.
Large solid image wrinkles
the master.
Increase the print speed or se-
lect photo mode.
Problem
Cause
Action
Prints are blank or parts of the
image are not printed.
Original size and direction are
not correct.
You cannot use originals of
different sizes and directions
in Combining Originals
mode. Use originals of same
size and direction.
Print image is not correct.
Original set order is not cor-
rect.
Place originals face up into the
optional document feeder.
The first original should be on
the top.
Place original face down on
the exposure glass. The first
original should be set first.
PinkGold-F_V4_FM.book Page 73 Tuesday, September 11, 2001 6:31 PM