Lantronix xPrintServer User Manual - page 7
7
7. LEDs
LEDs are located in two places on the
x
PrintServer device, and provide information about
device activity and status.
Ethernet LEDs. There are two “Ethernet LEDs” located on the upper left and right corners of
the Ethernet port: One yellow when lit, and the other green. The display and pattern of
each LED provides specific status information for the network connection:
Ethernet LEDs
Description
Solid Yellow
Indicates that a link to the Ethernet is established
Flashing Yellow
Indicates activity
Solid Green
Indicates an Ethernet connection speed between 10 and 100 Mbps
Green Off
Indicates an Ethernet connection speed of up to 10 Mbps
Status LED. The “Status LED” on the
x
PrintServer device is incorporated in the “x” letter of the
Lantronix logo on the top of the device. The Status LED is orange when lit, and specific display
patterns indicates specific status and activity. The LED may display a solid light, display no
light, slowly glow on, slowly glow off, or flash on/off. The status of the device is
communicated by following the specific glow and flash patterns and number of cycles.
Status LED
Description
Solid Orange
Indicates the power is ON or the device is booting
Off
Indicates the power is OFF
Glow On – Dim Off
(repeating pattern)
Repeating pattern of glowing on to glowing off cycle occurring once
every three (3) seconds indicates the device is booted and IDLE
Fast and Flashing
Indicates activity in progress (i.e., actively printing a print job)