Loadrite Sprint User Manual - 2.1.
2-10
LOADRITE Sprint User manual
2.
THE DAY-TO-DAY WEIGHING PROCESS
The following is the basic process for day-to-day weighing with the LOADRITE Weighing System:
1) Turn on the Indicator.
2) Perform
a
warm-up.
3) Zero the empty bucket.
4) Weigh and add each bucketload.
5) When you have finished loading the truck, clear the short total.
6) When you have finished using the LOADRITE Weighing System, put the Indicator into
Standby
mode.
2.1.
HOW DO I TURN ON THE INDICATOR?
The LOADRITE Indicator will turn on automatically when you start the loader.
2.2.
HOW DO I PERFORM A WARM-UP?
For best weighing accuracy, the hydraulic fluid in the lift cylinders should be at normal operating temperature. This is achieved
by raising and lowering the empty bucket.
The above message will display if the Indicator has been turned off for more than one hour. If you see the above message, you
need to raise and then lower the empty bucket past the Trigger Point three times:
1) Raise the bucket past the Trigger Point.
2) Lower the bucket past the Trigger Point.
3) Repeat two more times until the message disappears.
When the warm-up has completed, the
Ready
screen will display.
2.3.
HOW DO I ZERO THE EMPTY BUCKET?
The Check Zero functionality is only available if selected at installation.
It is necessary to periodically "zero" the Indicator because small errors can occur due to a build-up of material in the bucket.
If you see the above message, you need to zero the empty bucket. The message will display:
Every 15 minutes for the first hour, and
Every 30 minutes thereafter (the default period is 30 minutes, but it may be set between 15-180 minutes).
Complete the following to zero the bucket:
IMPORTANT:
When weighing a load, the loader must be level, and the bucket must be empty and kept fully-rolled back.
1) Ensure that the loader is level and the bucket is empty.
2) Raise the empty bucket.
3) Press
.
The
Zero Updated
message will display, before the
Ready
screen is displayed.