Loadrite Sprint User Manual - 2.4.2.1. Auto-Add
2-12
LOADRITE Sprint User manual
2.4.2.1. Auto-Add
The Auto-Add functionality is only available if enabled at installation. Some features may not be available,
depending on your model of LOADRITE Weighing System.
The LOADRITE Weighing System can be set to automatically add a bucket load when lifted past the Trigger Point for a
specified number of seconds
OR
when the bucket is rotated forward to tip off the load. This means that you don't need to
press
after lifting each load.
Depending on installation setup:
Bucket loads may not be added if under a specified amount
Auto-Add
may be turned on or off via the
Setup Menu
or by pressing
(Auto-Add toggle).
2.4.2.1.1. Auto-Add toggle
The Auto-Add toggle functionality may or may not be available depending the configuration of your Indicator.
You can toggle between using Auto-add and using the normal add process from the
Ready
screen.
Turn Auto-Add on
1) From
the
Ready
screen, press
.
The
Auto-Add On?
message will display.
2) Press
.
The message will change to
Auto-Add On
and the
Total
screen will display.
Turn Auto-Add off
1) From
the
Ready
screen, press
.
The
Auto-Add Off?
message will display.
2) Press
.
The message will change to
Auto-Add Off
and the
Ready
screen will display.
2.4.3.
Remote Add button
The LOADRITE Weighing System has an optional
Remote Add
button which is normally mounted on or near
the lift lever. If the
Remote Add
button is installed in your loader you can use it interchangeably with the
button on the Indicator.
2.4.4.
Subtract a bucket load
This function can be useful when only part of a final load of loose material is required. Weigh and add a full bucketload, but only
tip the amount required into the truck. Then re-weigh and subtract the amount remaining by completing the following:
IMPORTANT:
When weighing a bucketload, the loader must be level with the bucket kept fully-rolled back.
1) Raise the bucketload smoothly past the Trigger Point.
2) The Indicator will beep,
(
Trigger light
) will illuminate and the weight of the current load, the short total and the
potential new weight will display.
3) Press
.
The
Bucket Subtract
message will display. The amount will be subtracted from the short total. The
Ready
screen
will display.