Loadrite Sprint User Manual - Appendix B: Span Calibration

7-24 

LOADRITE Sprint User manual 

7. 

APPENDIX B: SPAN CALIBRATION 

ADJUSTMENT 

This function allows small changes to be made to the LOADRITE Weighing System calibration if the bucket is modified, or if no 

accurate test weight was available when the LOADRITE Weighing System was calibrated at installation time. 

The adjustment is carried out by entering the total weight recorded at a weighbridge (scale house) and the corresponding total 

provided by the LOADRITE Indicator. 

To perform the adjustment, a security access code must be obtained from your LOADRITE installer. 

CAUTION

 The LOADRITE Weighing System alters its calibration every time this function is used. It is important that this 

function is only used once with a given set of data. If the same weights are entered again, the LOADRITE Weighing System will 

over-correct and its accuracy will be seriously impaired. 

1) Press 

. 

2) Select 

Setup...

, then press 

. 

3)  Enter the security access code provided by the LOADRITE installer, then press 

. 

4) Select 

Calibration Menu

, then press 

. 

The 

Calibration Menu

 will display. 

5) Select 

Adjust Span

, then press 

. 

6) The 

Adjust Span

 message will display briefly and then the 

LOADRITE Adjust Span

 screen will display. 

7)  Enter the total weight provided by the LOADRITE Indicator, then press 

. 

8)  Enter the total weight provided by the weighbridge, then press 

. 

9)  The LOADRITE Indicator briefly displays the 

Calibration Updated

 message, and then returns to the 

Calibration Menu

.