Loadrite Sprint User Manual - Remote-Add Button
9-30
LOADRITE Sprint User manual
R
Remote-Add Button
An additional
Add
button which is mounted in close
proximity to the loader controls and performs the same
function as the
Add
button on the LOADRITE Indicator.
The button enables the operator to add a load without
having to remove their hands from the loader controls.
S
Short Total
The running total amount of product loaded onto a truck or
carriage. The Short Total amount will continue to
accumulate until it is cleared using the
Clear
function.
Standby
A low-power mode which the Indicator should be set to
between jobs, for example, when the operator is moving
the loader and does not need to weigh a load.
T
Ticket
A printed record of a load.
May also be known as
Docket
.
Tip-off
The final bucket load adjustment, which allows you to tip a
measured amount of the product from the final bucket to
ensure an exact target weight is reached.
Transducer
See
Pressure transducer
.
Trigger
A sensor which responds to the position of the lift arms,
and informs the Indicator when to take a weight reading.
LOADRITE weighing systems have three types of trigger:
optical, rotary and magnetic.
Trigger Point
A point (or series of points) in the position of the lift arms
where a weight reading is taken.
W
Weighbridge
A platform scale for weighing vehicles.
Also known as
Ground Scale
,
Scale House
and
Truck Scale
.
Z
Zero/Zeroing
Sets the weight of the bucket to
0
. Zeroing is required to
reset the weight of the bucket from time-to-time. This is to
avoid inaccurate readings due to the build-up of material in
the bucket which can occur when operators are dealing
with wet or sticky materials.
See
also
Check zero
.