Mackie TT24 Quick Start Manual - And Aux 1
13
Quick-Start Guide
Quick
-Star
t Guide
Route channel 1 to Main output, Group 1,
and Aux 1
9. Press and hold the
L/R
button in the GROUP AS-
SIGN area (Figure 3-3) and activate channel 1’s
SELECT
button.
All the channel
SELECT
buttons light, indicating
that all channels are routed to the Main output. You
should hear your mic in the main speakers via the
master fader.
Now, let’s route the mic through Group 1 instead of
directly to L-R:
10. Press and hold the
L/R
button in the GROUP AS-
SIGN area and deactivate channel 1’s
SELECT
button (so it is not lit).
Channel 1 no longer sends signal to L/R.
11. Press and hold the
GRP1
button in the GROUP AS-
SIGN area and activate channel 1’s
SELECT
button.
The mic is now routed to Group 1.
12. Press and hold the
L/R
button in the GROUP AS-
SIGN area and activate Group 1’s
SELECT
button.
Group 1 is now assigned to L/R.
Use the channel, Group, and Master fader to listen
to the mic signal in the L/R speakers.
13. Press
AUX SENDS 1
in the V-POT CONTROL area
(Figure 3-3).
14. Adjust the Aux 1 level on channel 1 using the V-Pot.
15. Press the
AUX MSTR
QuickMix button (Figure
3-4).
16. Adjust Aux 1’s master level with the correspond-
ing QuickMix knob (see the Aux Master screen in
Figure 3-5).
You should hear your mic in the monitor speaker
attached to Aux 1.
RETURNS
MASTER
ANALOG
DIGITAL
GROUP ASSIGN/SELECT
MASTER
V-POT
CONTROL
AUX
SENDS
FX1
FX2
FX4
FX3
ANLG
MUTE
DGTL
1
RTNS
5
MSTR
SELECT
PFL
SOLO
MUTE
2
6
SELECT
SOLO
MUTE
3
7
SELECT
SOL
O
MUTE
4
8
SELECT
SOLO
CTR/
MONO
L/R
SELECT
PAN
HPF
AUX
MODE
2
4
6
8
10
12
CLEAR
SOLO
TRIM
METERS
AUX
PAN
1
3
5
7
9
11
Group Assign/Select buttons
Master Center/Mono Assign button
Master Left/Right Assign button
Master Select button
Group Select buttons
V-Pot Control
Aux Sends
Bank Select
Clear Solo and
PFL buttons
Group Faders
p
Group Mute buttons
Master Fader
Group Solo buttons
Aux Mode
AUX
AUX
Figure 3-3 Aux, Group, and Master areas