Mackie TT24 Quick Start Manual - 3.4 Aux Functions
15
Quick-Start Guide
Quick
-Star
t Guide
Connect CD to channels 23 and 24
1. Move the CD to the channel 23 and 24
LINE
con-
nectors.
2. Set the
LINE
switch to the down position (line
level).
3. Press and hold channel 23
and
24’s
SELECT
switches until the Link Channels dialog appears in
the Touchscreen.
4. Touch
OK
to approve the channel linking.
5. Press the
PAN
button in the V-POT CONTROL area
(Figure 3-3).
6. Turn channel 23’s V-Pot hard left. Channel 24
automatically pans in the opposite direction. Pretty
cool!
7. Activate the
SOLO
button above the fader on either
channel to solo. The linked channel
does not
also
solo.
8. Adjust the channel’s
GAIN
knob and watch the
meters to the right of the Touchscreen.
The level should be between –7 and –10 dBFS.
9. Repeat steps 7 and 8 for the other channel in the
linked pair.
NOTE: Stereo linking always operates on a consecutive odd/even
channel pair. The odd channel’s parameters are copied to the even
channel except Pan, which is inversely linked (i.e., hard left on odd
channel translates to hard right on even channel).
Adjust EQ, Dynamics, and channel routing
1. With channel 23 and 24 selected, press the
EQ
but-
ton in the QuickMix area to display the channel EQ
screen in the Touchscreen.
2. Touch the
EQ IN
toggle switch on the screen.
3. Use the 12 V-Pots to adjust the EQ parameters.
4. Press the
DYN
QuickMix button to display the
Comp/Gate screen in the Touchscreen.
5. Touch the
GATE IN
or
COMP IN
toggle switches on
the Touchscreen to engage the processors.
6. Use the 12 V-Pots to adjust the dynamics param-
eters.
NOTE: Press the Gate or Compressor graph on the Touchscreen to
access a larger view of the individual dynamics processors.
7. Press the
GRP/AUX
QuickMix button to display the
Group/Aux routing screens.
Groups 1–8 buttons on the Touchscreen are used
for channel routing. The 12 V-Pots are used to
adjust the Channel Aux send levels.
8. Push the V-Pot knobs to toggle each Aux send
between pre- and post-fader.
3.4 Aux Functions
This section discusses how to setup, route, and mix
the Aux buses. Each of the 12 Aux masters have their
own EQ and compressor/limiter.
1. Display the Aux masters by pressing the
AUX
MSTR
button (Figure 3-4) to the right of the
QuickMix knobs.
2. Select Aux master 1 by pressing the top-left Quick-
Mix knob. Figure 3-7 (left) shows Aux 1 selected.
3. Touch the EQ grid or press the
EQ
QuickMix button
to display the EQ output parameters for selected
Aux send 1 (right of Figure 3-7).
NOTE: The EQ IN/OUT button is located on the upper right of the
Touchscreen.
The EQ has six bands:
Figure 3-7 Aux Master (left) and EQ (right) screens