Mackie TT24 Quick Start Manual - Aux Routing Examples

16

TT24 DIGITAL LIVE CONSOLE

TT24 DIGIT

AL LIVE C

ONS

OLE

•  two full parametric bands (bands 2 and 3); 

•  high- and low-shelf filters (bands 1 and 4); 

•  two Kill filters (bands 5 and 6) to remove narrow 

bands of unwanted frequencies. Push the Kill filter 

knobs to cycle through -6, -12, or -18 dB. As the 

amount of cut increases, the filter Q increases (i.e., 

bandwidth narrows). Turn the knob to adjust the 

frequency. 

The channel aux levels are set with the channel 

V-Pots by pressing the desired Aux number in the V-POT 

CONTROL area. All 12 Aux levels for a selected channel 

can be set by pressing the 

GRP/AUX

 QuickMix button. 

Aux Routing Examples 

To send mic channel 1 to all monitors: 

1.   Press channel 1’s 

SELECT

 button. 

2.   Press the 

GRP/AUX

 QuickMix button. 

3.   Adjust the QuickMix knobs to set each Aux level. 

To set one monitor mix: 

1.   Press the desired Aux number button in the AUX 

SENDS area. 

2.   Use each channel’s V-Pots to set the mix. 

Figure 3-8 Internal Effects and Reverb screens

3.5 Effects 

Four effects processors can each use one of the fol-

lowing effects: reverb, reverb through gate, mono/stereo/

ping pong delay, chorus, and flange. The default effect 

sends are Aux sends 9–12 but any Aux or Matrix sends 

can be used. The effect returns are on the Returns bank. 

1.  Press the 

ANLG

 bank button. 

2.  Press 

AUX SENDS 9

 in the V-POT CONTROL area. 

3.  Turn channel 1’s V-Pot to 3:00 to send channel 1 to 

Aux 9. 

4.  Press the 

EFX

 button in the QuickMix area. 

The INTERNAL effects screen displays on the 

Touchscreen (left of Figure 3-8). 

5.  Touch the Reverb’s 

Edit

 button to edit its param-

eters on its own screen (right of Figure 3-8). 

6.  Touch 

EFX IN

 to activate the reverb. 

7.  Press the 

RTRNS

 bank button. 

8.  Speak into the mic and increase the Returns levels 

(INT EFX 1L and INT EFX 1R) until you hear suf-

ficient reverb.