MACROZA Diamant D2 Instruction Ma - page 10
10
TO ADJUST DEPTH OF CUT-
DISCONNECT TOOL FROM POWER SOURCE.
Adjust the depth of cut as desired. The machine
swivels against a spring and the depth stop limits
its lowermost travel.
To adjust the depth of cut:
Loosen the depth lock knob (16) enough for the
teeth of the depth stop block (17) to clear the
teeth of the depth stop track (21). While pulling
out slightly to clear the teeth, slide the depth stop
block up or down as desired and retighten. See
fig.3.
HOW TO USE THE SIGHTING NOTCH
To aid in free-hand cutting, sighting notches are
located at the front of the base plate(23). See fig.
4. There are various markings which correspond to
various groove widths created by the different
spacers. Not all possibilities are covered so always
use the Zero mark corresponding to the inner blade
as the baseline for aligning.
VACUUM DUST COLLECTION
There is a vacuum port provided on the blade cover
(13) to collect dust when operating. Always make
use of it. Simply attach the vacuum cleaner hose
to the vacuum port. See fig. 5.
STARTING AND STOPPING TOOL
Make sure that the power circuit voltage is the
same as that shown on the specification plate of
the machine and that switch is “OFF” before con-
necting the tool to the power circuit
Switching the machine on and off
Keep the machine steady during switching and dur-
ing use by holding the main handle and the sec-
ondary handle with both hands. See fig. 6.
Depth stop block(17)
Depth scale
Depth stop track(21)
Depth stop knob(16)
Fig.3
Sighting notches
Fig.4
Vacuum port
Fig.5
START
STOP
1
2
Fig.6
Lock Button