MACROZA Diamant D2 Instruction Ma - page 5
5
Symbols used in this manual
V……..volts
A……..amperes
Hz……hertz
W……..watt
~………alternating current
n0………no load speed
/min……..revolutions or reciprocation per minute
………….class II tool
SPECIFIC SAFETY RULES
Keep hands away from cutting area and blade at all times! Keep your second
hand on an auxiliary handle.
If both hands are holding the saw, they cannot be cut
by the blade.
Do not reach underneath the work.
Hold tool by insulated gripping surfaces when performing an operation
where the cutting tools may contact hidden wiring or its own cord.
Contact
with a “live” wire will make exposed metal parts of the tool “live” and shock the oper-
ator.
Always use blades with correct size and shape arbor holes.
Blades that do not
match the mounting hardware of the saw will run eccentrically, causing loss of con-
trol.
Never use damaged or incorrect arbor flanges or bolts.
The arbor flanges and
bolt were specially designed for your saw, for best performance and safety of opera-
tion.
Maintain a firm grip on the saw and position your body and arm in a way that
allows you to resist KICKBACK forces.
KICKBACK forces can be controlled by the
operator, if proper precautions aretaken.
Do not use a dull or damaged blade.
Use only recommended
blades, rated at the machine’s maximum rated RPM or
higher with correct arbor hole.
Tighten blade retaining bolt
and all clamps before operating.
Check the inside surfaces
of the arbor flanges as well as the sides of the blade for
freedom from any foreign matter.
Check the blade
for cracks or other damage before operation. Replace cracked or
damaged blade immediately. Carry out a test run without load for at least 30 seconds
before use.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.