MACROZA Diamant D2 Instruction Ma - page 12

NOTE:

Only operate the machine forwards relative to itself and never backwards. If you

cut backwards there is the danger that the machine might be accelerated out of the cut-

ting groove (recoil) and cause serious injury. Therefore, when making vertical chases from

top to bottom, the machine must be carefully held from the front.

CAUTION:

Keep the cord away from cutting area to prevent it from becoming

entangled in the workpiece.

Do not force the cut. Let the saw do the cutting at the rate of speed permitted by the type

of cut and workpiece.

SHARPENING DULL DIAMOND BLADES

If a lot of sparks are seen while cutting, this is a sign that the blade is becoming dull. To

create better diamond exposure (sharpen), make several cuts in a  special sharpening

stone for diamond blades or alternately use calcareous  sandstone.

MAINTENANCE

KEEP TOOL CLEAN

Periodically blow out all air passages with dry compressed air. All plastic parts should be

cleaned with a soft damp cloth. NEVER use solvents to clean plastic parts. They could pos-

sibly dissolve or otherwise damage the material. Wear safety glasses while using com-

pressed air.

THE CARBON BRUSHES

The carbon brushes are a normal wearing part and

must be replaced when they reach their wear limit.

See fig.8. To replace: simply remove the brush caps

(49) and withdraw the old brushes (48). Replace

with new brushes (always replace as a pair) ensuring

that they align properly and slide freely. Then replace

the brush caps. See fig.9. 

STANDARD ACCESSORIES

10mm hex wrench

If the replacement of the power supply cord is necessary, this has to be done by

the manufacturer or their agent in order to avoid a safety 

12

Fig.8

Fig.9

Brush Cap