MACROZA Diamant D2 Instruction Ma - page 6
6
Never start the tool
with the workpiece against the blade.
Allow the motor to achieve full speed
before cutting.
Important: After completing the cut,
release power switch and wait for coasting
blade to stop completely before putting the saw down
Never operate
the tool in an area with flammable solids, liquids, or gases. Sparks
from the commutator/carbon brushes could cause a fire or explosion.
There are certain applications for which this tool was designed.
The manufac-
turer strongly recommends that this tool NOT be modified and/or used for any appli-
cation other than for which it was designed. If you have any questions relative to its
application DO NOT use the tool until you have written the manufacturer and have
been advised.
Only use the machine for dry cutting in stone, concrete or masonry.
Use the auxiliary handles supplied with the tool.
Loss of control can cause per-
sonal injury.
Use a residual current device (PRCD) (not included) to protect from current
surges
.
Keep power supply cord clear from the working range of the machine.
Always
lead the cable away behind you.
Immediately switch off the machine if unusual vibrations or if other mal-
functions occur.
Check the machine in order to find out the cause.
Only use and store diamond blades according to the Manufacturer’s instruc-
tions.
Pay attention to the dimensions of the blades.
The diameter of the center bore
must engage the arbor without play. If not use any necessary reduction pieces or
adapters (supplied with the blade) to ensure a proper fit.
Take care to avoid hidden electric lines, gas and water pipes.
Check your
working area, e.g. with a metal detector before commencing work.
The dust that arises when working with this tool can be harmful to health.
Use a dust absorption system and wear a suitable dust protection mask and remove
deposited dust with a vacuum cleaner.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
25.