MACROZA Diamant D2 Instruction Ma - page 8
8
Electrical connection
The network voltage must conform to the voltage indicated on the tool name plate. Under
no circumstances should the tool be used when the power supply cable is damaged. A
damaged cable must be replaced immediately by an authorized Customer Service Center.
Do not try to repair the damaged cable yourself. The use of damaged power cables can
lead to an electric shock.
Intended use
This saw is designed exclusively for the creation of masonry grooves (parallel double cuts
in concrete, masonry and stone) for the purpose of placing water, electric or gas conduits.
The machine is designed to use a pair of parallel diamond blades (not included) with vari-
ous spacers to create different width grooves. This machine should not be used for cutting
other materials. The machine should not be converted or modified, e.g. for any other form
of use, other than as specified in these operating instructions. The user shall be liable for
damages and accidents due to incorrect use.
Extension cable
If an extension cable is required, it must have a sufficient cross-section so as to prevent
an excessive drop in voltage or overheating. An excessive drop in
voltage reduces the output and can lead to failure of the motor. The following table shows
you the correct cable diameter as a function of the cable length for this machine. Use only
U.L. and CSA listed extension cables. Never use two extension cables together. Instead,
use one long one.
Total Extension Cord Length (feet)
Cord Size (AWG)
25 16
50
12
100
10
150
8
200
6
UNPACKING
Carefully remove the tool and all loose items from the shipping container. Retain all pack-
ing materials until after you have inspected and satisfactorily operated the machine.
NOTE: An appropriate dry diamond blade must be mounted to the machine
before operating. Refer to the section of this manual: “INSTALLING THE BLADE”