MACROZA Diamant D2 Instruction Ma - page 9

 CARTON CONTENTS

1.

Wall Chaser Machine

2.

10mm Hex Allen Wrench

DO NOT OPERATE THIS TOOL UNTIL YOU READ AND UNDERSTAND THE

ENTIRE INSTRUCTION MANUAL.

INSTALLING THE DIAMOND BLADE AND ADJUSTING THE GROOVE

WIDTH 

-ENSURE THAT TOOL IS DISCONNECTED FROM POWER SOURCE.

To install the blade:

Remove any accumulated debris

in the guards and around the

arbor.

Place the inner blade in position

directly on the arbor (7) making

sure the  direction of rotation

arrow of the blade and the

arrow on the machine are in the

same direction.

Place as many spacers

(nos.3~6) as necessary to

achieve the desired groove

width. They are in sizes 15,12, 

10 and 2 x 5mm.

Place the outer blade in position.

Place all of the remaining  spacers on top of the outer blade (so that the arbor may  be

tightened).

Place the outer flange (2) in  position.

Screw in the arbor bolt (1) and press the arbor lock (36) to lock the arbor in position

(it may be necessary to turn the arbor slightly to allow the lock to  engage).

Tighten the arbor bolt with the supplied 10mm hex wrench (61).See Fig.2.

NOTE:

Use blades that have an arbor bore which can fit, and that are rated

for the machine’s maximum rated speed or higher.

REMOVING THE BLADE

-DISCONNECT TOOL FROM POWER SOURCE.

Removal is the opposite of installing the blade.

9

Fig.2

Arbor (7)

Blades

Spacers(3~6)

Arbor bolt(1)

Outer arbor flange(2)

Blades

1.

2.

3.

4.

5.

6.

7.

8.