Makita UC3020A Instruction Manual - Safety Instructions
3
............Chain brake released/applied
....................Prohibited!
..................Only for EU countries
Do not dispose of electric equipment
together with household waste mate-
rial!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment and its imple-
mentation in accordance with
national law, electric equipment that
have reached the end of their life
must be collected separately and
returned to an environmentally com-
patible recycling facility.
Intended use
The tool is intended for cutting lumbers and logs.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavo-
rable mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.35 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protec-
tive circuit breaker having slow tripping characteristics.
ENH016-4
EC-DECLARATION OF CONFORMITY
The undersigned, Kato, as authorized by, declare that
the MAKITA machines,
Type:
211
EU model identification No.:
UC3020A, UC3520A, UC4020A: M6 05 10 24243 064
complies with the standard safety and health require-
ments of the pertinent EU guidelines:
EU machinery guideline 98/37/EC, EU EMC guideline
2004/108/EC, Noise emission 2000/14/EG.
The requirements of the above EU guidelines were
implemented chiefly on the basis of the following stand-
ards: EN60745-2-13, EN55014-1, EN55014-2,
EN61000-3-2, EN61000-3-3. The conformity assess-
ment procedure 2000/14/EG was performed per Annex
V. The measured sound power level (Lwa) is 100 dB(A).
The guaranteed sound power level (Ld) is 101 dB(A).
The EU Type-Examination per 98/37/EG was performed
by: TUV Product Service GmbH, Zertifizierungsstelle,
Ridlerstra e 31, D-80339 M nchen.
CE2007
Tomoyasu Kato
Director
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
SAFETY INSTRUCTIONS
ENA001-2
WARNING:
When using electric tools, basic safety precautions, including the following,
should always be followed to reduce the risk of fire, electric shock and
personal injury. Read all these instructions before operating this product
and save these instructions.
For safe operations:
1.
Keep work area clean.
Cluttered areas and benches invite injuries.
2.
Consider work area environment.
Do not expose power tools to rain. Do not use
power tools in damp or wet locations. Keep work
area well lit. Do not use power tools where there is
risk to cause fire or explosion.
3.
Guard against electric shock.
Avoid body contact with earthed or grounded sur-
faces (e.g. pipes, radiators, ranges, refrigerators).