N&W Global Vending Kobalto Installation Operation & Maintenance - page 14
© by N&W GLOBAL VENDING S.p.A.
10
05-2008 3235-00
cLEaNINg tHE WaStE traYS
the waste trays can be easily extracted even if the door
is closed (see fig. 9) to enable the user to empty and
clean them quickly.
The coffee container capacity is higher than the waste
tray capacity (if no support cabinet is used).
the control software of the machine will signal that
the maximum number of dispensing cycles has been
reached by displaying the “empty tray” message. the
machine will be locked.
The waste trays shall be emptied without powering off
the machine (the door shall be closed) to enable the
software to recognize the operation.
It is also possible to reset the counter by typing a pass-
word.
If there is no solid waste tray, the machine is ready to dis-
pense instant drinks. the “Insert the tray” message will
appear on the display.
to remove the solid waste trays, lift the telescopic noz-
zles completely and lower down the dispensing compart-
ment cover by turning it downwards.
dISaSSEmbLINg aNd cLEaNINg mIxErS
the mixers and the hoses intended to dispense instant
drinks and dispensing nozzles shall be carefully cleaned
and sanitized at the time of the installation and at least
once a week or more frequently, according to the use
of the machine and the quality of inlet water in order to
guarantee the compliance of dispensed products with
sanitary rules.
the parts to be cleaned are listed here below:
- dispensing nozzles, dividing nozzle and telescopic noz-
zle cover;
- powder deposit drawers, mixers and the hoses intend-
ed to dispense instant drinks.
to disassemble the parts, act as follows:
- remove the powder funnels, the water funnels, the
collection boxes, the powder deposit drawers and the
whipper motor impellers from the mixers (see fig. 9);
- unscrew the knurls at the bottom of the telescopic
-
nozzles
- press the clip at the back of the section at the bottom of
the nozzle cover and extract it downwards
- extract the tubes from the nozzles and from the dividing
nozzle
- remove the nozzles from the small support plate
- remove the dividing nozzle by pressing the clip at the
bottom of the small plate
- to disassemble the water funnel, turn the green ring nut
counterclockwise;
pay special attention on reassembling it: it shall be
completely closed;
-to disassemble the impellers, use a finger to lock the
-
disk mounted on the whipper motor shaft (see fig. 10).
then turn the impeller to unscrew it.
-
Fig. 10
Fig. 9
Liquid waste tray
1-
Removable grill
2-
Dispensing compartment back
3-
Telescopic nozzles
4-
Solid waste tray presence switch
5-
Telescopic nozzles
6-
Steam nozzle
7-
Steam cock (supplied)
8-
Dispensing compartment presence switch
9-
Dispensing compartment lock knurl
10-
Overturning grill
11-
Red drip tray full indicator
12-